Pointing- Re-pointing, Tuck-pointing

Re-pointing

Re-pointing is the process of carefully removing deteriorated or cracked mortar from brick or stone masonry joints and replacing with fresh mortar.  This fresh mortar must be carefully mixed in order to achieve similar chemical and structural properties as the original mortar.  The deteriorated mortar is usually ground down to a depth of 1/2" to 3/4" depending upon the width of the joint, the type of masonry,and the level of deterioration .  Re-pointing should never be used as a structural repair method. Loose brick or stone should be removed and replaced or re-installed. The purpose of this procedure is to ensure that water does not enter the masonry and damage its integrity or any structural elements behind it. Re-pointing is an essential maintenance operation that should be performed by a trained restoration mason. When done properly this procedure will not only enhance the beauty of the structure,but will ensure its functionality for generations to come.

Pointing

Pointing is the process of finishing joints in masonry with mortar when the work is originally being done.
We are experts in Brick,Stone,Granite,Limestone,Sandstone,
and Terracotta,Pointing, Re-pointing, and Tuck-pointing.

 

Tuckpointing

Tuck-pointing consists of a flush mortar joint with a protruding mortar line running through each joint. Mortar is sponged over the brick to a smooth finish.  A sealer is then applied with coloring to lift the color in the bricks,  The walls are then marked with chalk to identify where the tuck-pointing will be applied.  Masking tape is put on the wall and white mortar is troweled over.  While still wet the tape is removed to leave a thin line 2-3 mm wide.